Page 255 - CATALOG

CABLE RAILING

SWAGELESS NON-TENSIONING FITTINGS FOR WOOD POSTS

Push-Lock® Push-Lock® fitting is installed into a pre-drilled hole in
the end post. Using the Push-Lock® fitting on level runs
requires that a minimum of 1-1/2” of clearance exists on
the back side of the end post. It is also recommended
Push-Lock® Lag
that a stainless steel flat washer be installed between the
shoulder of the fitting and the mating surface of the wood
post. The cable attaches to the fitting via the Push-Lock®
Push-Lock® locking wedge system.
Lag Clevis

CABLE ITEM
DIA. NO.
1/8" PL-4-12
Pull-Lock® 3/16" PL-6-12

Push-Lock® w/Lag Clevis fitting is installed into a Push-Lock® Lag fitting is installed into a pre-drilled hole STAINLESS & CABLE RAILING
pre-drilled hole in the wood end post. Drive the lag in the wood end post by rotating the fitting to drive the
thread into the hole until the fitting shoulders on the lag thread into the hole until the fitting shoulders on the
post face. The cable attaches to the body via the Push- post face. Because the wrench flat is at the back of the
Lock® locking wedge system. fitting, it can be used with sleeved posts as well. The cable
attaches to the fitting via the Push-Lock® locking wedge
system.

CABLE ITEM
DIA. NO.
1/8" PL-LAG-CL-TE4-1
3/16" PL-LAG-CL-TE6-1 CABLE ITEM
DIA. NO.
1/8" PL-LAG-4
3/16" PL-LAG-6

Pull-Lock® fitting is installed into a pre-drilled hole in the
end post. Using the Pull-Lock® fitting on level or pitched
runs requires that a minimum of 1-1/2" of clearance exists
on the back side of the end post. It is also recommended
that a stainless steel flat washer be installed between
the shoulder of the fitting and the mating surface of the
wood post. The cable attaches to the fitting via the
Push-Lock® locking wedge system.

CABLE ITEM
DIA. NO.
1/8" PUL-4-12
3/16" PUL-6-12
T: 908.757.2323 ✛ F: 908.757.3439
AISALES@ARCHIRONDESIGN.COM ✛ ARCHIRONDESIGN.COM 253